RE: Error

["Mark Tinka" <mtinka at africaonline.co.ug>]

Looks like collisions on your router and switch interfaces.

Check to see that you are running your switch port at 10Mbps/Half Duplex.
The 2611 only supports 10Mbps. After you do this, do a "sh int e0/0" to
ensure you see no errors on your router interface. You should also check
your corresponding switch port to see no errors.

Worst case, you may try to use auto-negotiation for this connection, as long
as you have set auto speed on your router interface, and auto speed/auto
duplex on your switch port.

Regards,

Mark Tinka - CCNA
Network Engineer, Africa Online Uganda 

-----Original Message-----
From: owner-afnog at afnog.org [mailto:owner-afnog at afnog.org] On Behalf Of
Richard Mikisa
Sent: Thursday, June 19, 2003 9:49 AM
To: afnog at afnog.org
Subject: Error


Hi all,
This is an output I get off my 2611 router when I do a show log. Does
anybody 
Know what this means. The eth0/0 interface is plugged into a catalyst 2950 
switch.

*Mar 30 23:37:15.174 UTC: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error
*Mar 30 23:37:15.294 UTC: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error
*Mar 30 23:37:15.366 UTC: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error
*Mar 30 23:37:15.386 UTC: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error
*Mar 30 23:37:15.422 UTC: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error

-- 
cheers
Richard



-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put your
request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org





-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org