[afnog] Cisco ASR 1k trouble

Tue May 19 07:59:15 UTC 2015

Hi AfNOG,

I have some trouble and hope someone can help
(or send me to c-nsp...???)

Just switched on a Cisco ASR 1002 router.
We have 3 in use, this 4th one was in storage a few years, never used
before.

It starts fine.
I could upgrade IOS-XE from USB. fine.

both before and after that upgrade, I can not see the in-built
interfaces. As seen below, "show platform" says the Slot 0 (or the
module in it) is "disabled".
Now this is the slot where the in-built "SIP-10" is located, and this
shows ok in our other routers of same model.

Is this a hardware issue?

I did
SNET-TZ-KIP-CR1(config)#no hw-module slot 0 shutdown
SNET-TZ-KIP-CR1(config)#end
SNET-TZ-KIP-CR1#

and this didn't change anything.
more output below...

Thanks,
Frank

SNET-TZ-KIP-CR1#show platform
Chassis type: ASR1002

Slot      Type                State                 Insert time (ago)
--------- ------------------- --------------------- -----------------
0                             disabled              01:02:42
R0        ASR1002-RP1         ok, active            01:02:42
F0        ASR1000-ESP5        ok, active            01:02:42
P0        ASR1002-PWR-DC      ps, fail              01:01:24
P1        ASR1002-PWR-AC      ok                    01:01:24

Slot      CPLD Version        Firmware Version
--------- ------------------- ---------------------------------------
0         N/A                 N/A
R0        08011017            12.2(33r)XNB
F0        07091401            12.2(33r)XNB

SNET-TZ-KIP-CR1#show platform diag
Chassis type: ASR1002

Slot: 0,
  Running state               : disabled
  Internal state              : offline
  Internal operational state  : disabled
  Physical insert detect time : 00:01:11 (01:02:46 ago)
  Software declared up time   : 00:00:00 (never ago)
  CPLD version                : N/A
  Firmware version            : N/A

Slot: R0, ASR1002-RP1
  Running state               : ok, active
  Internal state              : online
  Internal operational state  : ok
  Physical insert detect time : 00:01:11 (01:02:46 ago)
  Software declared up time   : 00:01:11 (01:02:46 ago)
  CPLD version                : 08011017
  Firmware version            : 12.2(33r)XNB

Slot: F0, ASR1000-ESP5
  Running state               : ok, active
  Internal state              : online
  Internal operational state  : ok
  Physical insert detect time : 00:01:11 (01:02:46 ago)
  Software declared up time   : 00:03:00 (01:00:57 ago)
  Hardware ready signal time  : 00:01:12 (01:02:46 ago)
  Packet ready signal time    : 00:03:05 (01:00:53 ago)
  CPLD version                : 07091401
  Firmware version            : 12.2(33r)XNB

Slot: P0, ASR1002-PWR-DC
  State                       : ps, fail
  Physical insert detect time : 00:02:29 (01:01:28 ago)

Slot: P1, ASR1002-PWR-AC
  State                       : ok
  Physical insert detect time : 00:02:29 (01:01:28 ago)

SNET-TZ-KIP-CR1#

all log messages since boot:
*Jan  1 00:04:29.577: dev_pluggable_optics_selftest attribute table
internally inconsistent @ 0x121

*Jan  1 00:04:31.736: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled
for type vlan
*Jan  1 00:04:33.642: %LINK-3-UPDOWN: Interface Lsmpi0, changed state to up
*Jan  1 00:04:33.643: %LINK-3-UPDOWN: Interface EOBC0, changed state to up
*Jan  1 00:04:33.643: %LINEPROTO-5-UPDOWN: Line protocol on Interface
VoIP-Null0, changed state to up
*Jan  1 00:04:33.644: %LINEPROTO-5-UPDOWN: Line protocol on Interface
LI-Null0, changed state to up
*Jan  1 00:04:33.644: %LINK-3-UPDOWN: Interface GigabitEthernet0,
changed state to down
*Jan  1 00:04:33.661: %LINK-3-UPDOWN: Interface LIIN0, changed state to up
*Jan  1 00:04:33.918: %NETCLK-5-NETCLK_MODE_CHANGE: Network clock source
not available. The network clock has changed to freerun

*Jan  1 00:04:34.543: %IOSXE_MGMTVRF-6-CREATE_SUCCESS_INFO: Management
vrf Mgmt-intf created with ID 1, ipv4 table-id 0x1, ipv6 table-id 0x1E000001
*Jan  1 00:04:34.882: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Lsmpi0, changed state to up
*Jan  1 00:04:34.884: %LINEPROTO-5-UPDOWN: Line protocol on Interface
EOBC0, changed state to up
*Jan  1 00:04:34.886: %LINEPROTO-5-UPDOWN: Line protocol on Interface
GigabitEthernet0, changed state to down
*Jan  1 00:04:34.886: %LINEPROTO-5-UPDOWN: Line protocol on Interface
LIIN0, changed state to up
*Jan  1 00:04:38.820: %SYS-5-CONFIG_I: Configured from memory by console
*Jan  1 00:04:38.829: %IOSXE_OIR-6-INSCARD: Card (fp) inserted in slot F0
*Jan  1 00:04:38.830: %IOSXE_OIR-6-ONLINECARD: Card (fp) online in slot F0
*Jan  1 00:04:38.925: %IOSXE_OIR-6-INSCARD: Card (cc) inserted in slot 0
*Jan  1 00:04:39.209: %SYS-5-RESTART: System restarted --
Cisco IOS Software, ASR1000 Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M),
Version 15.3(3)S5, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Tue 27-Jan-15 23:08 by mcpre
*Jan  1 00:04:39.397: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF
*Jan  1 00:04:39.397: %CRYPTO-6-GDOI_ON_OFF: GDOI is OFF
*Jan  1 00:06:21.766: %SYS-5-CONFIG_I: Configured from console by console
*Jan  1 00:09:34.037: %NETCLK-5-NETCLK_MODE_CHANGE: Network clock source
not available. The network clock has changed to freerun

*Jan  1 00:51:17.662: %SYS-5-CONFIG_I: Configured from console by console
*Jan  1 00:52:08.054: %SYS-5-CONFIG_I: Configured from console by console