RE: Eth0 does not come up after kernel recompiling

["Mark Tinka" <mtinka at africaonline.co.ug>]

Perhaps the module was not compiled into your new kernel.

If you still have a copy of your .config file, please check it to verify
whether your card was among the modules listed to be compiled as either
static or loadable.

Regards,

Mark Tinka - CCNA
Network Engineer
Africa Online Uganda
5th Floor, Commercial Plaza
7 Kampala Rd,
Tel:   +256-41-258143
Fax:   +256-41-258144
E-mail: mtinka at africaonline.co.ug
Web:     www.africaonline.co.ug


-----Original Message-----
From: owner-afnog at afnog.org [mailto:owner-afnog at afnog.org]On Behalf Of
David Chima
Sent: Wednesday, April 16, 2003 12:45 PM
To: afnog at afnog.org
Subject: Eth0 does not come up after kernel recompiling


Hello
I have a problem. I have RedHat 7.2. I re-compiled my kernel as per the
instructions I
got from afnog. I updated my lilo.conf file to reflect the new kernel. The
machine booted
but eth0 did not come up. I checked /proc/modules and my 3Com card module
wasnt
there. I tried to use insmod to install it but it was in vain. It gives me
the fillowing error:

3c59x.o: unresolved symbol netdump_mode

What should I do?

Regards

David

-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org





-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org